Stabila HL-100 Manuel d'utilisateur télécharger pdf (Page 6)

3.3 Working in Vertical / Plumb mode

I. Mark the desired plumb point with

a cross.

II. Center the HL 100 roughly over the

marked cross, using the cross-

hairs on the back of the unit (12).

III. Center the bulls eye bubble (9) by using both dials, as shown underneath.

The horizontal setting dial (3) allows you to move the bubble sideways;

the vertical setting dial (4) allowsyou to move the bubble back and forth.

IV. Continue to drill

The laser is now correctly aligned.

Drill the second hole by setting the drill bit directly on the center of the laser

dot location. Clear the debris from the hole, if necessary, to allow laser beam

to pass through. The laser dot will now show the correct location of the hole

to be drilled on the third joist / stud. Continue to drill the following joists /

studs by using the center of the laser dot as the exact hole location.

You may prefers to mark the center of the dot with a pencil prior to drilling.

IV. Check the position of the HL 100

over the cross and slightly correct

position if necessary.

The HL 100 is now correctly positioned and plumb, ready to continue.

Drill hole in overhead material using the laser dot to place drill bit, or mark

the dot with a pencil and then drill.

1 2 3 4 5 6 7 8 9

Pas de commentaire

Stabila HL-100 Manuel d'utilisateur Page 6